Media Coverage: ‘Solar At Night’ Project Resolves Grid’s Storage Gap

A campaign has been launched to ensure Australia’s future energy system includes the multiple hours of daily storage required for users to have access to reliable energy solutions overnight. Without investment in such storage solutions, Australia risks increased night-time price volatility and unnecessary reliance on fossil-fuel generation, Australia’s peak body for Solar Thermal has warned.

In launching its Solar At Night campaign website, the Australian Solar Thermal Research Institute (ASTRI) is warning that as the amount of renewable generation increases, long-duration intra-day storage, of greater than 12 hours, is required to ‘firm’ intermittent wind and solar PV generation and to displace fossil-fuel generation.

‍

The new Website can be found here: https://www.solaratnight.com.au/

While battery storage technology is cost-effective for up to four hours, ASTRI says the most critical emerging ‘storage gap’ is in the 12–15 hour market for firm ‘Overnight’ power generation capacity.Overnight power is current provided by coal and gas, and investment in low-emission overnight energy storage will allow Australia to significantly reduce its emissions.

Concentrated Solar Power (CSP) uses mirrors to concentrate the sun’s energy in the form of high-temperature heat. The heat is stored and then used, as required at night, to generation electricity. CSP systems store sufficient energy to generate synchronous and fully dispatchable power for up to 15 hours.

“The successful uptake of wind and solar PV generation in the National Energy Market is driving emissions out of our electricity sector, but its variability and overnight scarcity requires the support of firm capacity.This is paradoxically making us more reliant on coal and gas,” said Director of ASTRI, Dominic Zaal. We need an ability to time-shift our abundant day time solar resources to meet our night time energy needs. “We need a ‘Solar at Night’ capability, where energy users have access to reliable and cost-effective renewable energy, from sunset to sunrise.

Mr Zaal said there are only a few utility-scale options to achieve this outcome, including pumped-hydro, compressed air, Hydrogen and CSP. Given our abundant solar radiation, CSP makes a lot of sense as option in hot dry locations in Australia’s future energy landscape.

‍

There are over 100 operational CSP systems, all of which are located in regions with high solar radiation. It is ironic that Australia, with the highest solar radiation levels in the world, has not yet deployed a utility scale CSP system

‍

The best way to deploy solar thermal in Australia is to integrate it with solar PV to optimise the respective strengths of each technology. Solar PV is the lowest cost form of renewable energy during the day, but it can be intermittent, and overnight storage with batteries is expensive. CSP is expensive for day time generation, but it is one of the lowest cost forms of overnight renewable power. Combining the two technologies is the ideal solution for 24/7 renewable power in hot dry locations within Australia.

‍

“We have created a website that educates Australians on the benefits of CSP, and we will be ensuring thatAustralia’s greatest untapped energy source – the sun – is not left out of the future electricity grid,” said Mr Zaal. “The Energy Ministers have agreed to put emissions goals into the planning of their state systems, and that means we can no longer put the long-duration storage gap on the back-burner. It will have to be dispatchable and zero emission and we believe CSP is a good technology option to do that.”

ASTRI was established by the Federal Government to facilitate increased awareness and commercial uptake of solar thermal technologies. The Institute represents industry, academics, and other key stakeholders in the Solar Thermal industry.

‍